STEP/SEQUENCE
RESULT
WHAT TO DO NEXT
TM 9-2320-363-20-1
Section 4
TROUBLESHOOTING CHARTS
D. CHART - 8 - NO "STOP ENGINE" LIGHT (SEL) DURING BULB CHECK (Cont'd)
C 8-7
Check ECM
Connectors
Check terminals at both 5-way
Terminals and
Reprogram ECM Then go to
power harness and vehicle
connectors
C8-30
harness connectors (both ECM
are okay.
and harness side) for damage;
bent, corroded, and unseated
Problem found.
Repair terminals/connectors.
pins or sockets. Pay close
Then go to C8-30.
attention to terminals 82 and
B3 of vehicle harness connector
and D and E power harness.
C 8-30
Verify Repairs
Turn ignition off.
"Stop Engine"
Repairs are complete.
Reconnect all connectors.
light comes on for
Turn ignition on.
up to 5 seconds
Clear codes.
then goes out.
Turn ignition off.
Turn ignition on while at same
"Stop Engine"
All system diagnostics are
time observing "Stop Engine"
light come on
complete. Please review this
light.
and stays on.
section from the first step to find
error.
Change 3 3-345.109
