TM 9-2320-303-10
NOTES:
1.
FRONT AXLE WHEEL BEARINGS.
Daily, check that level of gear lubricating
oil is visible in sight glass. If oil is not
visible, remove rubber plug and add GO
until level is even with plug opening.
Install rubber plug.
2.
POWER STEERING RESERVOIR.
Daily, with engine running and fluid at
operating temperature, remove dipstick
from
reservoir
and
check
level
of
lubricating oil on dipstick. Add OE/HDO to
bring level above the ADD mark on
dipstick.
3.
RADIATOR.
WARNING
Let
radiator
cool
remove
removing cap. Remove cap in
two steps. First place thick cloth
over cap and slowly turn cap left
to its first stop; pause, and allow
pressure to escape from cooling
system. Then turn cap further left
until you can remove it. Failure to
follow this procedure can result in
serious burns.
Daily, with engine cool, remove radiator
cap. Check level of coolant in radiator.
Coolant must be within 2 1/2 in. (6.4 cm)
below filler neck. Add coolant to correct
level. Install radiator cap.
4. ENGINE CRANKCASE. Daily, check
level of lubricating oil. Wait 10 minutes
after shutting down engine to allow oil to
drain back into crankcase. To ensure an
accurate reading, vehicle must be parked
on level ground. Safe operating level is
between ADD and FULL marks on dipstick.
As required, add OE/HDO through filler
opening. DO NOT overfill.
F-11