TM 9-2320-302-34
0106 00-5
HOOD SMC REPAIR - CONTINUED
0106 00
REPAIR - CONTINUED
l.
If patch (10) is close enough to edge, use clamps to temporarily secure patch during repair. If patch is too far from
edge to use clamps, use bond strips (17).
(1)
Cut scrap SMC into strips (17). Make enough strips to hold patch (10) in place, about one every 6 in (15
cm). If surface of patch is contoured or curved, use many small strips. Larger strips could deform curves.
(2)
On engine side of hood (12), use 220 grit sandpaper to scuff-sand areas on hood and patch (10) where
strips (17) will be bonded.
12
13
14
11
10
8
12
15
13
16
10
14
10
9
8