61.3
TROUBLESHOOTING FLASH CODE 61
2. Measure resistance between that cavity and the cylinder block.
[a] If measured resistance is less than 10 , the wire is shorted to the engine. Repair or
replace the harness and refer to section 61.3.5.
[b] If measured resistance is greater than 10 , go to step 3.
3. Remove the valve cover to gain access to the cylinder associated with the code.
4. Remove the connector terminals at the injector solenoid(s).
5. Measure resistance between that cavity and the appropriate return cavity (G or E).
[a] If measured resistance is less than 5 , the wire is shorted to the return wire. Repair
or replace the harness and refer to section 61.3.5.
All information subject to change without notice.
61-6
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION
