DDEC TROUBLESHOOTING
45.3 TROUBLESHOOTING FLASH CODE 45
Perform the following steps to troubleshoot Flash Code 45.
45.3.1
Multiple Code Check
Perform the following steps to check for multiple codes.
1. Turn vehicle ignition switch ON.
2. Plug in the diagnostic data reader (DDR)
3. Read active codes.
[a] If codes other than 110/1 are logged, service them first.
[b] If code 110/1 is logged, and no other codes are logged, there was an engine running
condition at which oil pressure was lower than it should have been.
NOTE:
For information concerning low oil pressure level, refer to section 3.1 in the engine
service manual.
All information subject to change without notice.
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION
45-5
