DDEC TROUBLESHOOTING
[b] If terminals and connectors are not damaged, replace the SRS. Refer to section 42.3.14.
Figure 42-8
Engine Harness Connector to Synchronous Reference Sensor
42.3.13 Check Timing Reference Sensor Connectors
Perform the following steps to check the TRS connectors.
1. Check terminals at the TRS (both the TRS and harness end) for damage: bent, corroded,
and unseated pins or sockets or bad contacts. See Figure 42-9.
[a] If terminals and connectors are damaged, repair them. Refer to section 42.3.16.
All information subject to change without notice.
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION
42-11
