TROUBLESHOOTING FLASH CODE 42

SAE J1587 EQUIVALENT CODE FOR FLASH CODE 42

Figure 42-3 Engine Harness Connector to Synchronous Reference Sensor

TM-9-2320-302-20 Truck Tractor Yard-Type: 43 500 LB GVW DED 4x2 Army Model M878A1 (Ottawa Model 60) (NSN 2320-01-121-2102) Manual
Page Navigation
411

DDEC TROUBLESHOOTING 42.3 TROUBLESHOOTING FLASH CODE 42 The following procedure will troubleshoot Flash Code 42. 42.3.1 Resistance Check Perform the following steps to check resistance. 1. Turn vehicle ignition OFF. 2. Disconnect engine harness connector at ECM. 3. Measure resistance between sockets S1 and S2 on the engine harness connector. See Figure 42-2. [a] If the resistance measurement is less than or equal to 200 , refer to section 42.3.2. [b] If the resistance measurement is greater than 200 or open, refer to section 42.3.3. Figure 42-2 ECM Engine Harness Connector 42.3.2 Check for Short Perform the following steps to check for a short. 1. Disconnect the SRS Connector. 2. Measure resistance between sockets S1 and S2 on the engine harness connector. See Figure 42-3. 3. Measure resistance between socket S1 and ground, and between socket S2 and ground. All information subject to change without notice. 6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION 42-5

Privacy Statement
Press Release
Contact