35.3
TROUBLESHOOTING FLASH CODE 35
[b] If resistance measurement is less than or equal to 100 , a short exists between
sockets where less than 100
resistance was read. Repair short and reinsert fuses.
Refer to section 35.3.8.
Figure 35-4
ECM Vehicle Harness Connector
35.3.7
Check ECM Connector
Perform the following steps to check the ECM connector:
1. Inspect the terminals at the ECM connector (ECM and harness side) for damage: bent,
corroded, and unseated pins or sockets.
[a] If the terminals and connector are damaged, repair both and refer to section 35.3.8.
[b] If the terminals and connector are not damaged, refer to section 35.3.4.
35.3.8
Verify Repairs
Perform the following steps to verify repairs:
1. Turn ignition switch OFF.
2. Reconnect all connectors.
3. Turn ignition ON.
4. Clear codes.
5. Start and run the engine for one minute.
6. Stop engine.
All information subject to change without notice.
35-8
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION
