23.3
TROUBLESHOOTING FLASH CODE 23
[b] If the measured resistance is less than or equal to 5 , refer to section 23.3.5.
Figure 23-5
ECM Engine Harness Connector
23.3.5
Check ECM Connectors
Perform the following steps to check the ECM connectors:
1. Check terminals at the ECM harness connector (both ECM and harness side) for bent,
corroded, and unseated pins or sockets. See Figure 23-6.
[a] If terminals and connectors are damaged, repair them. Refer to section 23.3.6.
All information subject to change without notice.
23-8
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION
