22.3
TROUBLESHOOTING FLASH CODE 22
[b] If resistance between sockets A and C is less than or equal to 1,000
or
open, the 5V wire (#916) is shorted to the return (#952). Repair the short and
refer to section 22.3.15.
Figure 22-5
ECM Vehicle Harness Connector
22.3.12 Check for Open +5 Volt Line
Perform the following steps to check for an open +5 volt line:
1. Install a jumper wire between sockets A (return #952) and C (5V #916) on the TPS
harness connector.
2. Measure resistance between sockets A3 and C3 on the vehicle harness connector.
See Figure 22-6.
[a] If resistance between sockets A3 and C3 is less than or equal to 5
or open,
refer to section 22.3.10.
All information subject to change without notice.
22-10
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION
