14.3
TROUBLESHOOTING FLASH CODE 14
[b] If terminals and connectors are not damaged, replace the CTS/OTS.
Figure 14-8
ECM Engine Harness Connector
14.3.11 Verify Repairs
Perform the following steps to verify repairs.
1. Turn vehicle ignition OFF.
2. Reconnect all connectors.
3. Turn vehicle ignition ON.
4. Clear codes.
5. Start and run the engine for eight minutes.
6. Stop engine.
7. Check DDR for codes.
[a] If no codes are logged, troubleshooting is complete.
[b] If code 110/3 or 175/3 and any other codes are logged, all system diagnostics are
complete. Review this section to find the error. Refer to section 14.3.1.
[c] If any codes except code 110/3 or 175/3 are logged, refer to section 9.1.
All information subject to change without notice.
14-12
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION
