11.3
TROUBLESHOOTING FLASH CODE 11
[b] If the terminals and connectors are not damaged, contact DDC Technical Service.
Refer to section 11.3.12.
Figure 11-5
Electronic Control Module Vehicle Harness Connector
11.3.10 Check for Short to 5 Volt
Perform the following steps to check for a short:
1. Turn ignition OFF.
2. Disconnect the vehicle harness connector at the ECM.
3. Disconnect the connector at the hand throttle sensor.
4. Measure resistance between sockets A and C on the hand throttle sensor harness connector.
See Figure 11-6.
[a] If the resistance measurement is greater than 1,000 , refer to section 11.3.11.
All information subject to change without notice.
11-10
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION
