10.13
FIRE TRUCK PRESSURE GOVERNOR FAULT
10.13.9.5
Engine Parameter Display
Engine r/min, oil pressure, temperature, and system voltage are displayed continuously while
the EFC is in operation. In addition, any diagnostic code accompanying a Check Engine or Stop
Engine condition will be displayed on the Information Center message display. An audible alarm
will also be activated with the code.
10.13.10 Programming the Electronic Fire Commander
Programming the EFC is simply a matter of selecting items from a menu:
To enter the programming menu, press and hold the MODE and MENU buttons at the
same time until "Press Idle to Exit" is displayed on the information center, then release
both buttons.
Moving through the menu is accomplished by pressing the MENU button.
Changing a selection in the menu is performed by using the INC and DEC switches.
Exiting the programming menu is accomplished in one of two ways.
Press IDLE to exit the menu and save changes.
Press MODE to exit the menu without saving changes.
All information subject to change without notice.
10-58
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION
