TM 9-2320-302-20
0206 00-5
CAB DOOR ADJUSTMENT - CONTINUED
0206 00
ADJUSTMENT - CONTINUED
15.
Loosen torx screw (14) and add or remove shims (15) as necessary to center striker pin (12) and door latch jaws (13).
NOTE
•
Steps 16 through 19 must be performed from inside and outside of cab.
•
Repeat steps 16 until door fully closes without difficulty.
16.
Fully close cab door (8). If cab door was difficult to close or would not close, open cab door, loosen torx screw (14), and
move striker pin (12) inward.
17.
Tighten torx screw (14) to 37-42 lb-ft (50-57 Nm).
NOTE
Repeat steps 18 until door opens without difficulty.
18.
Open cab door (8). If cab door was difficult to open or would not open, loosen torx screw (14) and move striker pin (12)
outward.
19.
Tighten torx screw (14) to 37-42 lb-ft (50-57 Nm).
INWARD
OUTWARD
8
8
15
13
12
13
14
