6.1
BASICS
6.1.1
ECM Programming
The following label is attached to the ECM. See Figure 6-1.
Figure 6-1
ECM Label
Every DDEC system engine serial number has its own file in the DDC Mainframe.
NOTICE:
Failure to match the serial number on the engine with
the ECM programming may result in incorrect calibration
results and engine damage.
ECM programming must be done to match the serial number you are currently working on.
Failure to do so may result in incorrect calibration and engine damage.
Programming a DDEC III ECM must be done with an engine file set up for the DDEC III
system.
Programming a DDEC IV ECM must be done with an engine file set up for the DDEC IV
system.
For a summary of features and how to change them, refer to section 7.
All information subject to change without notice.
6-4
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION
