TM 9-2320-302-10
0006 00-2
OPERATION UNDER UNUSUAL CONDITIONS - CONTINUED
0006 00
SLAVE START TRUCK - CONTINUED
1.
Connect NATO slave cable to receptacle (1) on “dead” vehicle.
2.
Connect other end of NATO slave cable to receptacle on “live” vehicle.
3.
Place master battery switch to ON.
4.
Start engine of “live” vehicle and run at 1000 rpm until voltmeter of “dead” vehicle is in
green band. Stop engine and remove NATO slave cable from receptacle.
CAUTION
Ensure voltmeter of “dead” vehicle is in GREEN band before pushing starter
button.
5.
Start engine of “dead” vehicle (WP 0005 00). If engine will not start, notify Unit Mainte-
nance.
TOW TRUCK
1.
General.
a.
Notify Unit Maintenance to send recovery vehicle and tools required to disconnect
propeller shafts.
b.
Refer to FM 21-305 for general guidelines on vehicle recovery and use of warning
kits and signals. Refer to FM 21-305 and FM 20-22 for additional information.
CAUTION
Propeller shafts must be disconnected and inter-axle lockout control valve
lever must be in UNLOCK position before towing truck with all wheels on
the ground. Failure to follow this caution may result in transmission damage.
c.
When towing truck with front axle and rear tandem on ground, ensure that inter-
axle lockout control valve lever is in UNLOCK position. Ensure that universal joint
on rear of propeller shaft (at the input to the forward-rear axle) is disconnected and
tied up to vehicle undercarriage.
1
