TM 9-2320-283-10
h. Press the ETHER QUICK-START button for 4 to 5 seconds and release to
automatically inject a set amount of ether into the intake manifold while crank-
ing the engine. At temperatures below O°F it may be necessary to repeat steps
g and h.
i. After the engine starts, maintain an idle speed of 560-650 rpm.
j. While performing step i, observe the oil pressure gage. At low idle speed the gage should indicate
at least 10 psi at normal operating temperature.
k. Observe all instruments for proper indications. Also, observe warning lamps for
the following:
The ENG OIL (Low Oil Pressure) warning lamp should go off.
The Low Air Pressure warning lamp and buzzer should go off.
The Park Brake warning lamp should remain on until the Park Brake is releas-
ed. Dont release the park brake until the low air pressure lamp and buzzer
shut off.
2-59