TM 9-2320-273-20
BRAKE SYSTEM.
9-11.1. AIR DRYER REPAIR (Continued).
LOCATION/lTEM
ACTION
REMARKS
C. INSPECTION AND REPAIR.
NOTE
All repair consists of replacing defective
parts discovered during inspection and re-
placing discarded parts with new items
provided.
19.
Inspect all parts for damage
and serviceability.
20. End cover assembly (17).
a. Connect a 12VDC source to
end cover housing (35). Con-
nect a positive lead to elec-
trical terminal (34), and a
negative lead to the outer
shell of the head assembly.
b. Expose end cover housing
(35) to temperatures below
50°F (9.9° C). If the heat-
ing element is working
properly the outer shell
should become warmer
within a few minutes. If the
outer shell does not become
warmer, the end cover
housing must be replaced.
D. ASSEMBLY.
NOTE
When installing two mounting brackets (40),
aline them with the marks on the air dryer
housing (2).
21. Air dryer housing (2), two
a. Install two screws (43).
mounting brackets (40).
b. Install and tighten two lock-
washers (42) and two
nuts (41).
22. Air dryer housing (2).
Apply antiseizing tape and
install nipple (12) and two pipe
plugs (1).
Change 2 9-34.3
