TM 9-2320-273-20
OIL SYSTEM
4-14. ENGINE OIL SERVICE (Continued).
LOCATION/lTEM
ACTION
REMARKS
H. INSTALLATION OF BYPASS FILTER.
22. Two mounting brackets (10).
a. Position over eight mounting
studs (9).
b. Secure with eight Iockwashers
(14) and nuts (15).
23. Two elbows (22).
a. Coat threads with liquid teflon.
b. Screw into canister (23).
24. Canister (23).
Secure to two mounting brackets
(10) with two clamps (24), eight
bolts (12). Iockwashers (13), and
nuts(11).
25. Filter to pump line (20) and
Screw onto two elbows (22).
and filter to sump line (21).
26. Bypass filter element (8).
Place into canister (23).
27. Pack hold down assembly
a. Place thru center of bypass
(28).
filter element (8) in canister
(23).
b. Screw all the way down to the
stop.
28. Cover (4) and new cover
Set in place on canister flange (25).
gasket (5).
29. Clamping ring (6).
a. Position over cover (4) and
canister flange (25).
b. Secure with two clamping bolts
(7); draw up bolts until they
stop against shoulder.
30. Vent plug (2) and washer (3).
Install at cover (4) and tighten.
l. REPLENISHING OIL.
31. Filler cap (1).
a. Remove.
b. Pour oil thru filler cap opening.
See LO 9-2320-273-12.
c. Tighten filler cap.
OEA IF SUB-ZERO.
J. CHECKING FOR LEAKS.
32. Engine.
a. Start up.
See TM 9-2320-273-10.
b. Run 3-5 minutes, shut
off and let set 8-10 minutes.
4-30
