TM 9-2320-273-20
WINCH.
12-10. RESERVOIR SCREEN AND STRAINER MAINTENANCE (Continued).
LOCATION/lTEM
ACTION
REMARKS
1. Fill cap with chain (1).
Unscrew.
2. Drain plug (6).
Unscrew and drain fluid into
clean container.
3. Nut (11).
a. Loosen.
Slide upper cover (10), two
b. Remove nut (11) with
gaskets (9) and lower cover,
other hand.
with stud (8) to the side with
one hand.
4. Upper cover (10), two
Lift out of reservoir (5).
Discard gaskets (9).
gaskets (9), and lower
cover with stud (8).
5. Pump inlet strainer (7).
Unscrew and remove.
6. Six screws (12).
Remove and lift out retainer
Inspect gaskets (3). If damaged,
(2), two gaskets (3), and
make from stock using old
flange and screen (4).
gasket for a template.
B. CLEANING.
Do not allow dry cleaning solvent SD-2 to
come in contact with seals or flexible hoses.
Such cleaners may damage leather, rubber,
and synthetic materials.
7. Flange and screen (4)
a. Clean with dry cleaning
If damaged, replace.
and pump inlet strainer (7).
solvent.
b. Allow to dry.
C. INSTALLATION.
8. Flange and screen (4), two
Place in reservoir fill opening
gaskets (3) and retainer (2).
and secure with six screws (12).
9. Pump inlet strainer (7).
Insert thru access hole and
screw onto pipe.
10. Lower cover with stud (8),
a. Hold in position with one
two new gaskets (9), and
hand at access hole in
upper cover (10).
reservoir (5).
b. Install nut (11) and tighten.
To keep parts in proper position
first turn nut (11) by hand while
pulling up. Once snug, tighten
with wrench.
12-18
