TM 9-2320-273-20
BRAKE SYSTEM.
9-35. PUSHER AXLE BRAKE SHOES MAINTENANCE (Continued).
LOCATION/lTEM
ACTION
REMARKS
If you replace any brake shoe, replace all the
shoes on that axle. A combination of new
and old shoes on the same axle wiII cause
uneven braking. Make sure that the brake shoes
are clean before you install them. Be careful
not to get grease or oil on the linings as you
assemble them.
10.
11.
12.
13.
14.
15.
16.
17.
O-ring (13), seal (8),
washer (7), and camshaft
(14).
O-ring (9), seal (8),
washer (7), snap ring (6),
and grease fitting (12).
Two bushings (3) and
grease fitting (4).
Two brake shoe assemblies
(27).
TWO pins (5), two washers
(2) and two snap rings (1).
Two washers (2) and two
snap rings (1).
Spring (26) and two pins (23).
Two rollers (25) and two
retainers (24).
Install bushings (10) and
(11), O-ring (13), seal (8),
washer (7), and then install
camshaft (14) thru bushings
(10)and(11).
Install.
Install into spider.
Place on spider.
Install snap ring (1) on pin
(5) with washer (2) and push
through brake shoe assembly
(27) and bushing (3).
Install washer (2) on back side
of pin (5) and install snap ring
Install pins (23) and hook UP
spring (26).
With long handle screwdriver
raise brake shoe to allow
room to install roller (25)
and retainer (24).
(1).
Repeat operation for opposite
s h o e .
9-154
