TB 9-2320-279-13&P-3
0031
INSTALLATION - MODEL B (A2 VEHICLE) - CONTINUED
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death, keep away from open fire and
use in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water.
8. Apply pipe thread sealing compound to the thread of the small compression fitting base (33).
9. Route black wire (20) and white wire (17) through compression fitting base (33) and install cable (19),
rubber seal (21), plastic washer (22), and compression nut (18).
10. Connect black wire (20) with blade connector to existing blade connector (15). If connectors do not mate,
remove both blade connectors and connect wires with butt splice connector. Cover with heat-shrink.
11. Install white wire connector (17) with screw (16).
0031-31
