TB 9-2300-420-20-1
PARKING BRAKE PAWL ADJUSTMENT - Continued
CAUTION
Do not allow shaft (K) to turn or damage to control (L) will result.
15. Using two 9/16 inch combination wrenches, loosen two nuts (U) and (V) on end of shaft (K).
16. Push or pull shaft (K) until 1-1/8 inch gage block just fits between cotter pin (Q) and nut (J).
17 With gage block in place, rotate upper nut (U) until metal to metal contact exists between upper nut (U) and lever
assembly (X).
18. Using 9/16 inch wrench, back off upper nut (U) 1-1/2 turns.
19. Using two 9/16 inch wrenches hold nut (U) and lock lower nut (V) securely against upper nut (U).
NOTE
Proceed to step 25.
LEFT SIDE SHOWN
RIGHT SIDE SAME
MULTI-PIECE LEVER AND PAWL
WITH TWO JAM NUTS
TA 173258
20