EQUALIZING BEAM REPAIR (CONT)
Use general cleaning methods to clean all parts (page 2-30).
Inspect all parts for wear or damage.
Use press plate, P/N 51100, or support equalizing beam bore square on press
bed. Failure to do so could result in bent beam, requiring replacement.
Procedure is the same for all vehicles except as noted.
M915A2 Only: Installation of bushings requires 50-ton or larger press.
M916A1 Only: Installation of bushings requires 100-ton or larger press.
COAT ALL METAL SURFACES OF BUSHINGS WITH GAA.
21-4 Change 1