TM 9-2320-363-34-2
Section II. STEERING GEAR REPAIR
This section illustrates
Steering Gear Repair
and describes procedures for maintenance of the steering gear and related parts.
Page
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
19-6
STEERING GEAR REPAIR
This task covers:
a. Disassembly b. Cleaning c. Inspection d. Assembly
INITIAL SETUP
Tools and Special Equipment:
Shop Equipment, SC 4910-95-CL-A31
Tool Kit, SC 5180-90-CL-N05
Torx Socket, XE-16
Spanner Wrench, J37070
Spanner Wrench, J37464
Trunnion Installer, J37071
Drive Handle, J8092
Input Seal Installer, J37073
Materials/Parts:
Kit, Seal
Bearing, Roller
Screw, Adjusting
Retainer
Fitting, Grease
Grease, Automotive
and Artillery (GAA)
Oil, Lubricating
Tape, Masking
Cloth, Abrasive
Equipment Condition:
Reference
Page 7-4
P/N TAS650003
P/N 071020
P/N 021200
PIN 062005
P/N 037027
Appendix B, Item 26
Appendix B, Item 37
Appendix B, Item 58
Appendix B, Item 10
Condition Description
Steering Gear Removed
General Safety Instructions:
W A R N I N G
Spilled hydraulic fluid is very
slippery. Wipe up any spilled
fluid immediately. Failure to
do so could result in serious
injury to personnel.
Do not allow valve housing to
contact poppet. Such contact
c o u ld
cause
s t e e r i ng
problems or loss of steering
resulting in possible injury to
personnel.
Do not force guide halves
i n t o p l a c e . F o r c e m a y
damage guide halves, which
could cause loss of steering
resulting in possible injury to
personnel.
Guide halves must be held in
place during installation of
balls. Failure to do so will
result in balls being trapped
outside closed ball track,
causing steering lockup and
possible injury to personnel.
Failure to install all 32 balls
in guide halves will cause
steering problems, resulting
in
p o s s i b le
i n j u r y t o
personnel.
19-8
