TM 9-2320-363-34-2
AIR COMPRESSOR REPAIR (CONT)
C A U T I O N
Tangs on one end of connecting rod bearing insert must be installed in
corresponding notches on one side of connecting rod cap to prevent damage
to equipment.
27. INSTALL NEW CONNECTING ROD BEARING INSERT (26) IN CONNECTING ROD CAP (27).
28. APPLY FILM OF CLEAN ENGINE LUBRICATING OIL TO CONNECTING ROD BEARING INSERT (26).
C A U T I O N
Connecting rod bearing insert tangs should be on same side of connecting
rod and connecting rod cap to prevent damage to equipment.
Make sure connecting rod is fully seated on crankshaft journal to prevent
damage to equipment.
29. POSITION CONNECTING ROD CAP (27) ON CONNECTING ROD (20) SO WIDE EAR (28) ON
CONNECTING ROD CAP (27) MATCHES CORRESPONDING EAR ON CONNECTING ROD (20).
30. INSTALL TWO CONNECTING ROD BOLTS (29) AND TIGHTEN TO 80-100 LB-IN (9-11 N.m).
31. POSITION NEW GASKET (30) AND CRANKCASE COVER (31) ON BOTTOM OF AIR COMPRESSOR
BODY (6).
12-134