TM 9-2320-363-34-1
N O T E
Perform steps 11 through 13 for M916A2, M917A1, and M917A1 w/MCS only.
11.
USING FLOOR JACK, SUPPORT REAR
END OF EQUALIZING BEAM (17).
REMOVE TWO NUTS (24), WASHERS
(25), AND BOLTS (26). DISCARD ALL
MOUNTING HARDWARE.
N O T E
Note position of shims, while lowering equalizing beam, to aid in installation.
12.
LOWER REAR END OF EQUALIZING BEAM (17) AND REMOVE SHIMS (27). TAG SHIMS FOR
INSTALLATION.
13.
LOWER FRONT END OF EQUALIZING BEAM (17) AND REMOVE SHIMS (27). TAG SHIMS FOR
INSTALLATION.
Use general cleaning methods to clean all parts (page 2-30).
Inspect all parts for wear or damage.
Change 1
9-31