Forward-rear axle differential carrier weighs 1,160 lb (526 kg). Attach suitable
floor jack prior to installation to prevent possible injury to personnel.
C A U T I O N
Make sure both mating surfaces have been completely cleaned to prevent
damage to equipment.
INSTALL DIFFERENTIAL CARRIER (2) ON FLOOR JACK AND ROLL DIFFERENTIAL CARRIER (2)
INTO POSITION UNDER VEHICLE.
W A R N I N G
Adhesives, solvents, and sealing compounds can burn easily, can give off
harmful vapors, and are harmful to skin and clothing. To avoid injury or
death, keep away from open fire and use in well-ventilated area. If adhesive,
solvent, or sealing compound gets on skin or clothing, wash immediately with
soap and water.
If axle assembly has been removed from vehicle, perform steps 3 thru 5 only.
APPLY 1/8-IN. BEAD OF SEALING COMPOUND AROUND MATING SURFACE OF AXLE (3).
ATTACH SUITABLE HOIST AND INSTALL DIFFERENTIAL CARRIER (2), TWO WASHERS (4), AND
TWO NUTS (5). DO NOT TIGHTEN NUTS,
INSTALL 10 WASHERS (6) AND 10 CAPSCREWS (7). TIGHTEN 10 CAPSCREWS (7) AND 2 NUTS
(5) TO 150-230 LB-FT (203-312 N.m).
CONNECT AIR LINE (8).