TM 9-2320-363-34-1
ENGINE RETARDER SOLENOID TEST AND REPLACEMENT (CONT)
C A U T I ON
Grasp only connector when removing wiring harness solenoid connector from
solenoid terminal. Do not pull on wire to prevent damage to equipment.
NOTE
Procedure is the same for all three solenoids.
1.
DISCONNECT WIRING HARNESS SOLENOID CONNECTOR (1) FROM SOLENOID TERMINAL (2).
2.
REMOVE SOLENOID
Three seal rings
bottom of engine
and discard seal.
3.
DISCARD SOLENOID
(3) FROM ENGINE RETARDER ASSEMBLY HOUSING (4).
NOTE
should come out with solenoid. If lower seal ring remains at
retarder solenoid housing bore, remove seal with piece of wire
(3) AND THREE SEAL RINGS (5, 6, AND
7).
4-54