TM 9-2320-363-34-1
Use general repair methods to repair damaged parts (page 2-33).
M 9 1 6 A 1
M916A2, M917A1, AND M917A1 w/MCS
1.
COAT LIP OF NEW OIL SEAL (5) WITH GREASE
2.
INSTALL OIL SEAL (5) IN BEARING CAP (6).
W A R N I N G
Adhesives, solvents, and sealing compounds can burn easily, can give off
harmful vapors, and are harmful to skin and clothing. To avoid injury or death,
keep away from open fire and use in well-ventilated area. If adhesive, solvent,
or sealing compound gets on skin or clothing, wash immediately with soap and
water.
3.
COAT END OF SHAFT (4) WITH SILICONE ADHESIVE-SEALANT.
4.
INSTALL AND SEAT YOKE (3) ON SHAFT (4).
5.
6.
INSTALL LOCK PLATE (2) AND TWO SCREWS (1). TIGHTEN SCREWS TO 60 LB-FT (81 N.m).
INSTALL LOCK PLATE (8) AND ONE SCREW (7). TIGHTEN SCREW TO 308 LB-FT (418 N.m).
N O T E
Follow-on Maintenance:
Fill transfer case with oil (TM 9-2320-363-20).
Install driveline (TM 9-2320-363-20).
Change 1
3-275