TM 9-2320-363-34-1
CAMSHAFT AND BEARINGS REPLACEMENT (CONT)
C A U T I O N
Be careful not to get gasket eliminator on camshaft bearing shell seats and
bearing surfaces. Keep time to minimum between installation of camshaft
bearing caps no. 1 and no. 7 and tightening of camshaft cap bolts and nuts.
Make sure two seal rings are placed on cylinder head before assembling
camshaft bearing caps to cylinder head Failure to do so could result in
damage to equipment.
NOTE
Make sure locating tangs are correctly positioned.
5.
APPLY THIN BEAD OF GASKET ELIMINATOR TO JOINT FACE SURFACES (A, B, C, AND
TWO CAMSHAFT BEARING CAPS NO. 1 AND NO. 7.
D) OF
3-176