CRANKSHAFT REAR OIL SEAL REPLACEMENT
This task covers:
a. Removal b. Inspection c. Installation
Tools and Special Equipment:
Shop Equipment, SC 4910-95-CL-A31
Tool Kit, SC 5180-90-CL-N05
Oil Seal Remover, J35993
Oil Seal Expander, J35685-A
Oil Seal Installer, J35686
Appendix B, Item 37
Appendix B, Item 10
Flex Plate Removed
If oil seal remover screws strip out of oil seal casing, remove screws and bolts.
Rotate oil seal remover 1/2 the distance between existing screw holes in seal
casing and repeat steps 1 thru 4.
POSITION OIL SEAL REMOVER (1) OVER REAR OF CRANKSHAFT AGAINST FLYWHEEL
Oil seal remover screws must be evenly snug against oil seal remover but not
overtightened and stripped in oil seal casing.
INSTALL SIX OIL SEAL REMOVER SCREWS (3) THRU INNER CIRCLE OF HOLES IN OIL SEAL
REMOVER (1) AND INTO OIL SEAL CASING.
THREAD THREE BOLTS (4) INTO OUTER CIRCLE OF HOLES IN OIL SEAL REMOVER (1) UNTIL
BOLTS CONTACT FLYWHEEL HOUSING (2).
WORKING CLOCKWISE, TURN EACH BOLT (4) ONE FULL TURN UNTIL CRANKSHAFT REAR OIL
SEAL IS REMOVED.