START ENGINE (Con't).
Perform steps i through l if outside temperature is at or below 32°F
Perform steps a through e.
· Never press ether quickstart button unless cranking engine
simultaneously. Buildup of ether fumes may result in combustion in
· DO NOT operate starter motor for more than 30 seconds at a time.
After 30 seconds, allow starter motor to cool for at least two minutes
before attempting to start engine again. Excessive heating of starter
motor may result in damage or early starter failure.
Press engine start button and at the same time press ether quick-start button
When engine starts, release engine start button.
DO NOT run engine above idle speed until oil pressure gage indicates
at least 15 psi (100 kPa) at idle speed.
Do not run engine above 600 rpm until normal oil pressure (15 psi) is indicated
on engine oil pressure gage.
Monitor gages and indicators. If after ten seconds there is no indication of oil
pressure, shut down engine (paragraph 2-16) and perform troubleshooting (Chapter 3,