TM 9-2320-302-34
0010 00-2
POWER PACK REPLACEMENT - CONTINUED
0010 00
NOTE
Tag all wires, cables, connectors, hoses, and tubes prior to removal to aid in installation.
REMOVAL
1.
Remove nut (1) and washer (2) and disconnect cable (3), ground strap (4), and three wires (5) from starter (6).
2.
Remove nut (7) and washer (8) and disconnect cable (9) and four wires (10) from starter solenoid (11).
3.
Remove nut (12) and washer (13) and disconnect two wires (14) from starter solenoid (11).
4.
Remove nut (15) and washer (16) and disconnect cable (17) and two wires (18) from plate (19).
5.
Remove screw (20), washer (21), bracket (22), and plate (19).
6.
Remove screw (23), bracket (24), and spacer (25) from engine block (26). Set cable harness (27) aside.
7.
Remove nut (28), washer (29), and wire (30) from fuel pressure sending unit (31).
8.
Disconnect electronic control module harness connectors (32 and 33) from connectors located at rear of ECM (34). Cut
tiedown straps as required to free harness (35) from engine. Discard tiedown straps.
22
14
13
12
19
18
17
16
15
4
3
1
2
5
6
2120
789
10
10
11
