FORWARD-REAR AXLE DIFFERENTIAL CARRIER REPAIR - CONTINUED
ASSEMBLY - CONTINUED
Pry bars must not touch bearing cones to prevent damage to bearing cones.
Loosen adjusting ring (48) on gear side of ring gear (2) until small amount of end play shows on dial indicator when ring
gear is moved left and right with two pry bars between two adjusting rings and ends of ring gear subassembly (50).
Tighten adjusting ring (48) loosened in step 51 until no end play shows on dial indicator.
Tighten two adjusting rings (48) one notch from zero end play measured in step 52. Bearing preload is now set.