TURBOCHARGER REPAIR - CONTINUED
ASSEMBLY - CONTINUED
Bearing axial clearance must be 0.0020-0.0032 in (0.051-0.081 mm). If bearing axial clearance does not
meet specification, replace turbocharger center housing assembly.
Apply manual pressure to compressor wheel and turbine wheel assembly to move assembly as far as it will go away
from turbine end of turbocharger (toward dial indicator plunger (10)). Note maximum shaft movement shown on dial
Repeat steps 5 and 6 several times to ensure maximum bearing axial clearance, as indicated by maximum turbine wheel
assembly movement, has been measured.
END OF WORK PACKAGE