TM 9-2320-302-34
0039 00-2
ACCESSORY DRIVE REPAIR - CONTINUED
0039 00
DISASSEMBLY - CONTINUED
2.
Place service kit holding fixture (3) in vise and remove accessory drive pulley lock nut (4). Discard lock nut.
3.
Remove accessory drive pulley (5) by tapping with rubber hammer or fiber mallet. Remove service kit holding fixture
(3) from vise.
4.
Position accessory drive assembly (1) on press bed with service kit holding fixture (3) supported. Using arbor press,
apply pressure through holding fixture access hole (6) and press accessory drive assembly (1) out of accessory drive
gear (7). Remove three screws (2) and accessory drive gear.
4
5
3
2
2
3
1
6
7