TM 9-2320-302-34
0036 00-7
CYLINDER BLOCK ASSEMBLY REPAIR - CONTINUED
0036 00
CLEANING AND INSPECTION - CONTINUED
10.
Measure cylinder liner counterbore diameter (A) and depth (B). Diameter should be 6.186-6.191 in (157.15-157.25
mm). Depth should be 0.3514-0.3533 in (8.9256-8.9746 mm).
ASSEMBLY
1.
Coat outside sealing edge of five 1-1/2 in diameter cup plugs (7) with loctite adhesive. Using single-side plug installer
and handle, install five cup plugs to 0.098-0.118-in (2.5-3.0 mm) below machined surfaces on right side of cylinder
block.
2.
Coat outside sealing edge of 1.062 in cup plug (8) with loctite adhesive. Using small end of double-ended plug installer
and driver handle, install cup plug 0.098-0.118 in (2.5-3.0 mm) below machined surface of rear of cylinder block.
3.
Install 3/8 in pipe plug (9) and pipe plug (12).
4.
Install four 1/4 in pipe plugs (10 and 11).
5.
Install stud (13).
A
B
13
12
7
7
8
9
11
10