TM 9-2320-302-34
0026 00-22
CAMSHAFT AND BEARINGS REPLACEMENT - CONTINUED
0026 00
INSTALLATION - CONTINUED
22.
Apply thin bead of gasket forming compound to camshaft bearing cap (23) no. 7 mating surface and install camshaft
bearing cap no. 7 on cylinder head (26).
23.
Install rear camshaft cover (2) and three bolts (1). Tighten bolts to 22-28 lb-ft (30-38 Nm).
24.
Install five camshaft bearing shells (24) in camshaft bearing caps (23) no. 2 through no. 6.
25.
Install five camshaft bearing caps (23) on correct saddles on cylinder head (26) and install two camshaft cap bolts (20)
hand tight in camshaft bearing caps no. 3 and no. 5.
26.
Install rocker arm assemblies (WP 0027 00).
27.
Tighten 12 camshaft cap and rocker arm bolts and nuts to 75-86 lb-ft (102-117 Nm), in sequence shown.
1
2
26
23
Cap no. 7
24
23
20
20
20
20
23
23
23
Cap no. 1
23
24
24
26