36.3
TROUBLESHOOTING FLASH CODE 36
[b] If resistance measurement is less than or equal to 100 , the signal line (#530) and
return line (#452) are shorted together. Repair the short. Refer to section 36.3.12.
Figure 36-5
Engine Harness Connector to Oil Pressure Sensor
36.3.12 Verify Repairs
Perform the following steps to verify repairs.
1. Turn ignition switch OFF.
2. Reconnect all connectors.
3. Turn ignition ON.
4. Clear codes.
5. Start and run the engine for one minute.
6. Stop engine.
7. Check DDR for codes.
[a] If no codes are logged, troubleshooting is complete.
[b] If code 100/4 is not logged, and other codes are logged, refer to section 9.1.
[c] If code 100/4 is logged, and other codes are logged, all system diagnostics
are complete. Please review this section from the first step to find the error.
Refer to section 36.3.1.
All information subject to change without notice.
36-10
6SE497 9709 Copyright © 1997 DETROIT DIESEL CORPORATION