FRONT QUICK-RELEASE VALVE REPLACEMENT - CONTINUED
REMOVAL - CONTINUED
Remove two lock nuts (3), washers (4), screws (5), washers (6), and quick-release valve (2) from crossmember (7). Dis-
card lock nuts.
Remove three elbows (8) from quick-release valve (2).
Adhesives and sealing compounds can burn easily, can give off harmful vapors, and are harmful to skin
and clothing. To avoid injury or death, keep away from open fire and use in a well-ventilated area. If
adhesives or sealing compound contacts skin or clothing, wash immediately with soap and water.
Ensure all air lines and fittings are clear of debris and excess pipe sealing compound does not enter air
lines or fittings. Failure to follow this warning could result in injury to personnel or damage to equip-
Lightly coat threads of three elbows (8) with pipe sealing compound. Install elbows in quick-release valve (2).
Install quick-release valve (2) on crossmember (7) with two washers (6), screws (5), washers (4), and new lock nuts (3).
Connect three tubes (1) to quick-release valve (2).
Start vehicle and build air pressure (TM 9-2320-302-10). Check for leaks.