REAR BRAKE SPIDER AND BRAKE CHAMBER
BRACKET REPLACEMENT - CONTINUED
REMOVAL - CONTINUED
Matchmark spider position prior to removal from axle flange to aid in installation.
Remove eight lock nuts (7), washers (8), flange bolts (9), washers (10), and spider (4) from axle flange (11). Discard
Position spider as matchmarked during removal.
Install spider (4) on axle flange (11) with eight washers (10), flange bolts (9), washers (8), and new lock nuts (7).
Tighten lock nuts to 150-175 lb-ft (203-237 Nm) in sequence shown.
Apply a light coat of GAA grease to two bushings (6) and new seals (5).
Install bushings with label ends facing each other. Install bushings to a depth of 3/8 in (9.5 mm) from each
end. Install each seal with lip facing slack adjuster.
Install two bushings (6) and seals (5) on spider (4).