ELECTRICAL CONNECTORS MAINTENANCE - CONTINUED
SPLICING - CONTINUED
Insert one wire into splice clip (P/N: 0597428 or equivalent) and crimp.
Insert other wire into splice and crimp (Figure 19).
Figure 21. Spliced Wire.
Soldering Splice Connectors. Soldering splice connectors is optional. To solder splice connectors:
You MUST use rosin core solder.
Check exposed wire before splice is crimped in connector. Exposed wire MUST be clean before splice is crimped.
Use a suitable electronic soldering iron to heat wires. Apply solder to heated wire (not to soldering iron) allowing
sufficient solder flow into splice joint.
Pull on connection to ensure crimping and soldering integrity.
Heat Shrinkable Tubing.
Shrink wrap is required. Alpha FIT-300, Raychem TAT-125 or any equivalent heat shrink dual wall epoxy encap-
sulating adhesive polyolefin is required. The following are sources of supply:
Alpha Wire Corp
711 Lidgerwood Ave
P.O. Box 711
Elizabeth, New Jersey 07207-0711
Raychem Corporation, Thermofit Div
300 Constitution Drive, Bldg. B
Menlo Park, CA 94025