OPERATION UNDER USUAL CONDITIONS - CONTINUED
INITIAL ADJUSTMENTS, DAILY CHECKS, AND SELF-TESTS - CONTINUED
If engaging Komfort Loc®, allow no more than 1 in. (2.5 cm) between
chest and shoulder strap.
Komfort Loc® will automatically release if pressure is applied to shoul-
If desired, engage Komfort Loc® (7) by pulling on shoulder strap (8) and pressing
Komfort Loc® lever up.
To release seat belt, press release button on buckle (5). If Komfort Loc® (7) was
engaged, give shoulder strap (8) a quick downward tug to release.
Refer to WP 0004 00 for the location of instrument panel controls and indica-
Ensure that parking brake is applied.
Ensure that all accessories are off and engine brake system switches are in OFF (down)
Turn ignition switch to ON position. Low air pressure warning light, PARK BRAKE
light (if applied), ABS light(s), and warning buzzer come on. ABS light(s) will go off
after passing a four second self-test.
Ensure that inter-axle lockout control valve lever is in UNLOCK position.
DO NOT operate starter motor for more than 30 seconds at a time. After 30
seconds, allow starter motor to cool for at least two minutes before attempting
to start engine again. Excessive heating of starter motor may result in damage
or early starter failure.
Press engine start button.
Fuel filter/water separator is located in engine compartment behind the left-
side frame rail, mounted on the engine block.