TM 9-2320-283-20-3
STEERING SYSTEM.
3-217.2. STEERING GEAR POPPET ADJUSTMENT (Continued).
LOCATION/ITEM
ACTION
REMARKS
ANALYZE/ADJUSTMENT.
NOTE
The following procedure sets the steering gear poppet
adjusting screws so that power steering system pres-
sure is reduced before the steering stop bolts contact the
axle beam boss. When at full lock (steering against axle
stops) the poppet should be fully tripped and pressure
shown on gage in discharge line should be between 450
and 900 psi (3103 and 6205 kPa).
1. Discharge line (1) on power steer-
ing pump (2).
Remove line at pump side only.
Change 1 3-1304.7