TM 9-2320-273-20
BODY AND CAB.
11-15. VENTILATOR MAINTENANCE (Continued).
LOCATION/lTEM
ACTION
REMARKS
A. REMOVAL (Continued).
3. Four screws (6)
Unscrew and remove.
4. Ventilator (5).
Remove.
5. Seal (4).
a. Inspect seal for deterioration.
If necessary, remove using a
suitable tool.
b. If seal is being replaced, cut
seal to desired length and
remove adhesive backing.
Install seal on ventilator
applying firm and even
pressure.
B. INSTALLATION.
6. Ventilator (5).
7. Four screws (6).
8. Two wire ends (7).
9. Two clips (1).
Set in place.
Screw in and tighten.
Slide onto two pins (3).
Fasten over cable wires (2).
NOTE
Follow-on maintenance action required:
Install heater; refer to paragraph 11-24B.
11-46