GENERAL MAINTENANCE INSTRUCTIONS - CONTINUED
USE OF SEALANT
When applying sealant, follow manufacturer's instructions on label of container.
Sealant should be applied with an even and continuous 1/4 inch bead along mating surfaces. Make semi-circular pattern
around bolt holes and studs.
When tightening fasteners, use torque value as specified in Torque Limits (WP 0043 00).
If a unique torque value is required, it will be provided in the procedural step of the task.
Use marker tags to identify all electrical wires and any other parts which may be hard to identify or replace later. Fasten
tags to parts during removal by wrapping wire fasteners around or through parts and twisting ends together. Position tags
out of the way during cleaning, inspection, and repair. Mark tags with a pencil, pen, or marker.
Whenever possible, identify electrical wires with the number of the terminal or wire to which it connects. If no markings
can be found, tag both wires or wire and terminal, and use the same identifying mark for both. If you cannot tag a wire
because it must fit through a small hole or you cannot reach it, write down the description of the wire and the point to
which it connects or draw a simple diagram on paper. Be sure to write down enough information so you will be able to
properly connect the wires during assembly. If you need to identify a loose wire, look for identifying number near end of
the wire, stamped on a permanent metal tag. Compare the number to wire numbers on the appropriate electrical sche-
Identify and tag other parts as required by name and installed location.
END OF WORK PACKAGE
0011 00-5/(0011 00-6 Blank)