TB 9-2320-360-13&P-1
A/C KIT INSTALLATION - CONTINUED
0003 00
IN-CAB COMPONENTS - CONTINUED
0003 00
WARN I N G
Always wear gloves and goggles when drilling and grinding. Failure to follow this warning may cause
injury to personnel.
CAU T I ON
Use caution when drilling and check for components behind panel. Failure to follow this caution may cause
damage to vehicle.
N OT E
The A/C and A/C engine fan control solenoid circuit breakers are installed in a similar manner. A/C circuit
breaker installation is shown.
Refer to WP 0057 00, for template of A/C and A/C fan control solenoid circuit breakers mounting location.
c.
Drill two 1/16-inch diameter pilot holes in loca-
tion shown on template.
d.
Drill two 7/16-inch diameter holes (2) in side of
electrical enclosure (3) as shown on template.
HETF00318
N OT E
20 amp circuit breaker is installed in forward hole and 5 amp circuit breaker is installed in rear hole.
e.
Install two circuit breakers (4) on electrical enclosure (3) with retaining nuts (5), ensuring screw terminals (6) are
pointing up.
f.
Install two knurled retaining nuts (7) on threaded shafts (8) of circuit breakers (4) outside electrical enclosure (3)
until flush with end of threaded shaft (8).
g.
Tighten two retaining nuts (5) to secure circuit breakers (4) to electrical enclosure (3).
HETF00319
0003 00-25