GENERAL MAINTENANCE INSTRUCTIONS - CONTINUED
USE OF THREAD ADHESIVE
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can cause lung irritation.
Contact with skin can cause dermatitis. Wear gloves and safety goggles and use product in a well-ventilated
area away from open flame. If ingested, keep individual calm and seek medical attention. DO NOT induce
vomiting. If contact with skin or eyes is made, flush thoroughly with water. Dispose of cleanup rags IAW
local policy and ordinances. Failure to follow this warning may cause injury to personnel.
Selected bolts and screws require use of adhesive during installation of the armor kit, or when replacing
armor kit components. Generally, if no locking fastener (i.e., locknut or lockwasher) is used, thread adhesive
USE OF SEALANT
When applying sealant, follow manufacturer's instructions on label of container.
Sealant should be applied with an even and continuous 1/4 in. bead along mating surfaces. Make semi-circular pattern
around bolt holes and studs.
When tightening fasteners, use torque value as specified in Torque Limits (WP 0026 00).
If a unique torque value is required, it will be provided in the procedural step of the task.
Use marker tags to identify all electrical wires and any other parts which may be hard to identify or replace later. Fasten
tags to parts during removal by wrapping wire fasteners around or through parts and twisting ends together. Position tags
out of the way during cleaning, inspection, and repair. Mark tags with a pencil, pen, or marker.
Whenever possible, identify electrical wires with the number of the terminal or wire to which it connects. If no markings
can be found, tag both wires or wire and terminal, and use the same identifying mark for both. If you cannot tag a wire
because it must fit through a small hole or you cannot reach it, write down the description of the wire and the point to
which it connects or draw a simple diagram on paper. Be sure to write down enough information so you will be able to
properly connect the wires during assembly. If you need to identify a loose wire, look for identifying number near end of
the wire, stamped on a permanent metal tag. Compare the number to wire numbers on the appropriate electrical sche-
Identify and tag other parts as required by name and installed location.
END OF WORK PACKAGE
0014 00-5/(0014 00-6 Blank)