TB 9-2320-279-13&P
0040
N OT E
This procedure covers installation of one high mount
stop lamp assembly. Installation procedures are the
same for both.
12. If pump module was equipped with high mount stop lamp assemblies, reinstall lamps in
new rear doors as follows:
a. Remove two screws (10), lockwashers (9), and rear light cover panel (19) from
rear door assembly (2) as shown in figure 9. Retain all fasteners for installation
and return cover panel (19) to stock.
b. Install lamp connector end of 3593651 right hand stop lamp extension harness (4)
or 3593652 left hand stop lamp extension harness (4) through lamp housing (6)
on front side of rear door assembly (2). Refer to figure 9.
c. Plug extension harness connector (12) onto stop light (11) and install stop light
(11) into rear door assembly (2). Secure stop light (11) with two screws (10)
and lockwashers (9) as shown in figure 9. Tighten screws (10) to 59 lb-in.
d. Remove two screws (8), lockwashers (7), and loop straps (5) from front side of
rear door assembly (2). Retain all parts for installation. Refer to figure 9.
e. Install two loop straps (5) around stop lamp extension harness (4) and secure to
front side of rear door assembly (2) with two screws (8) and lockwashers (7).
Tighten screws (8) to 41 lb-in. Refer to figure 9.
f. Route stop lamp extension harness (4) as required, in order to connect to existing
stop lamp harness connector (3). Secure stop lamp extension harness (4) with
wire ties as required. Refer to figure 9.
M. Complete fastener tightening sequence as follows:
1. Tighten two capscrews (12) securing grab/pull handle (10) to 21 lb-ft. Refer to figure 6.
2. Tighten four capscrews (4) securing top panel assembly (6) to rear panel assembly (8) to
60 lb-ft. Refer to figure 6.
3. Tighten five capscrews (2) securing top panel assembly (6) to right upper side panel
assembly (7) to 60 lb-ft. Refer to figure 6.
4. Tighten five capscrews (1) securing top panel assembly (6) to left upper side panel
assembly (9) to 60 lb-ft. Refer to figure 6.
5. Tighten two locknuts (13) securing right front panel assembly (12) to right lower side
panel assembly (1) to 60 lb-ft. Refer to figure 5.
0040-11